We will use this program to figure out the correct z-distance for your installed knife. #How to use inkscape to cut vinyl fullYou now have full control over your printer. The printer will go *clunk* and the lights will go out temporarily, this is normal. Choose the correct port (you can find that in the Device Manger in Windows under the "Ports" section) or just pick one from the list in Pronterface and try connecting until you find the right one. #How to use inkscape to cut vinyl installInstall Pronterface and connect your printer to your computer via USB. Push the holder into the mount in your printer and use a short M3 screw to secure it in place. I also recommend using some fine sandpaper to polish off any sharp edges on the front of the knife holder as it will be dragged across the vinyl. It will be obvious if you're cutting too deep or not deep enough. Try the setting on a piece of vinyl by pushing the holder up against the vinyl and dragging the knife in a circle. As you can see in the image, we're talking a tiny amount that the knife is sticking out. It's important to get this distance right or you will either not cut enough, which means you can't remove the excess vinyl, or you'll cut too deep and ruin your knife (good thing the knock-offs are cheap ). Install a knife into the holder and adjust the amount it sticks out so that it just barely cuts through your vinyl, but not through the paper backing. Attach it to the head using the screws that hold the fan shroud in place. It was made quick and dirty, but it works well enough. Print out the little mount that is included in the zip. Better Better DXF Output for Inkscape: Ī slightly modified version of the DXF exporter and dxf2gcode with my current settings are included in this zip: Vinyl transfer tape (or in my case, some random blue painters tape from tesa I had in the junk drawer that worked well) Some vinyl: Available from arts and craft stores, ebay, sign makers etc. The one I got was this: "15pcs 30°/45°/60° Degree For Roland Cutting Plotter Vinyl Cutter BladeHolder" What you need (if you want the software to be free): I've tried to make it as easy as possible to do but be prepared to do some tweaking and experimenting along the way. Get comfortable, this is going to take a while. Using a 3D printer to do this is nothing new, it has been done plenty of times before. Recently I started experimenting with cutting out vinyl stickers with my Ultimaker 2 and figured I'd share my method to save time for others if they want to do the same thing.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |